An all-in-one washer-dryer washes and dries in the same drum. It saves space, but it combines two machines worth of parts into one. When something goes wrong, you need a technician who understands both.
Our team repairs washer-dryer combos in Colorado Springs, including ventless and heat pump models.
Call (614) 543 4437 to book your combo unit repair.
Most combo units are ventless. They do not blow hot air outside. Instead, they remove moisture using either condensation or a heat pump.
This design means drying often takes longer than with a separate dryer. That is normal. Clothes that stay soaking wet are not.
Overloading is a common cause. Combos dry best with smaller loads. If loads are small and clothes are still wet, a heating part, fan, sensor, or condenser may be at fault.
A clogged drain pump or filter can stop both washing and drying, since drying also removes water through the drain.
Combos use many sensors. Error codes often point to a sensor, pump, or control issue. Write down the code before you call.
A door lock or control problem can keep the door locked.
Door gaskets and hoses are common leak points.
Moisture can linger in the drum and gasket. Regular cleaning helps.
Combo unit stuck on a cycle or leaving clothes wet? Call (614) 543 4437 now.
A combo unit washes and dries in the same drum, so it depends on a clear drain, a working condenser and steady airflow. Hard water scale and lint can coat the condenser and the heater, and an overloaded drum leaves clothes damp. Ventless models remove moisture with water cooling or a heat pump instead of a vent, so a blocked drain, a weak pump or a failed heater shows up as wet clothes and very long cycles. We check the drain, the condenser path, the heater and the sensors, then repair the part that failed.
When your washer dryer combo leaves clothes damp, a quick call saves time. Reach us at (614) 543 4437 or book online, and a local technician will explain what is wrong before any work starts.
Other makes and models are welcome. Call us with the brand, or see all the brands we repair.
Looking for washer dryer combo repair near you? We send local technicians across Colorado Springs and nearby communities. Our regular north and east side routes include Powers Boulevard, Cimarron Hills, Briargate and Northgate and Flying Horse. We also work in Old Colorado City, Old North End, Broadmoor and Manitou Springs, and we travel to Pueblo West, Pueblo, Cañon City and Larkspur for all in one washer dryers, ventless combos and compact units.
Not sure we cover your address? Call (614) 543 4437 and we will confirm your visit time.
Overloading is the most common reason. If loads are small, a failed heater, fan, or sensor may be the cause.
Yes. Ventless drying is slower than a traditional vented dryer. Several hours is not unusual on many models. Check your manual for your model's typical times.
Yes. Most combo units can be repaired.
Most do not. They are ventless and remove moisture through condensation or a heat pump.
Using the right amount of detergent, wiping the door seal and running a monthly cleaning cycle all help. Our hard water guide explains how local water affects appliances.
Codes usually point to the drain, the water level, the door lock or the heater. See our error code help page, or call us with the code and the brand.
In most cases, repair costs far less than buying a new one, especially when the appliance is not old. Our technician gives you an honest recommendation after the diagnosis. Not sure about yours? Read our repair or replace guide.
The cost depends on the failed part and your model. Our technician diagnoses the problem first and gives you the price before any work starts. For general guidance, read our repair cost guide.
Call (614) 543 4437 or book online for washer-dryer combo repair in Colorado Springs.
